540 PW

Stucco Repair & Install Front Door

BEFORE

 

DURING

While removing the door, we found signs of rotten wood

Since, there was rotten wood surrounding the door, the stucco and drywall had to be removed so we could replace the frame.

 Once the stucco and drywall had been removed, next task was to replace the frame and re-install the door.

After the frame had been replaced, the next step is to install the green board and Tyvek paper.

After everything has been sealed and waterproofed, it is time install the Stucco Lath and apply the first coat of stucco.

While on the inside, insulation form is sprayed around the door, the drywall replace, tapped & mudded ready for to spray texture.

Once the drywall mud and stucco has dried, its time to apply the texture.

AFTER

Once everything has dried, it is time to paint

502 CM

Turning a cracked bathtub into a a walk-in shower.

Master Shower Rebuild

The door frame showed signs of water penetration and the carpet felt damp to the touch.

 

BEFORE

Removed the baseboard and drywall and found the metal stud work to rusty

Removed the tile from the outside of the shower

And found that was a lot of moisture in the base of the shower

 Once we got the go ahead, we began work, first removing the glass and frame

 Removed the walls

Set up a de-humidifer to remove as must moisture as possible

 The wooden frame of the curb to the shower was moldy

 Starting to remove the floor of the shower

 Once everything had been removed, it was time to start rebuild

Once the 1/2 wall had been built, and the shower linen install it was time to start building the base of the shower

 

  Once the base had dried, it was time to install the Hardie-Backer and apply a moisture barrier for extra protection

Once that was done it was time to start tiling the walls

 Also tiled around the bathtub to help bring it all together

Once the walls were tiled, it was time to tile the floor and grout everything

AFTER